Thingiverse
Levlor Blind mounting bracket
von Alexristaino
1
Downloads
0
Likes
0
Makes
I made this levlor blind bracket to replace the ones I lost while moving.
Printed at 70% infill in generic PLA, I used the tri-hexagon infill pattern. Very strong and no issues.
V1 had printed threads and nuts but I did not feel it was strong enough so I cut a hole to insert a 3/16" bolt and wing nut.
I did not add the holes in the back of the bracket as they were not needed due to the way they mount in my window. I can add them though if someone needs it.
Works great! plenty strong even with my blinds you manually pull down.
Printed at 70% infill in generic PLA, I used the tri-hexagon infill pattern. Very strong and no issues.
V1 had printed threads and nuts but I did not feel it was strong enough so I cut a hole to insert a 3/16" bolt and wing nut.
I did not add the holes in the back of the bracket as they were not needed due to the way they mount in my window. I can add them though if someone needs it.
Works great! plenty strong even with my blinds you manually pull down.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
