Thingiverse
Levlor Blind mounting bracket
por Alexristaino
1
Descargas
0
Likes
0
Makes
I made this levlor blind bracket to replace the ones I lost while moving.
Printed at 70% infill in generic PLA, I used the tri-hexagon infill pattern. Very strong and no issues.
V1 had printed threads and nuts but I did not feel it was strong enough so I cut a hole to insert a 3/16" bolt and wing nut.
I did not add the holes in the back of the bracket as they were not needed due to the way they mount in my window. I can add them though if someone needs it.
Works great! plenty strong even with my blinds you manually pull down.
Printed at 70% infill in generic PLA, I used the tri-hexagon infill pattern. Very strong and no issues.
V1 had printed threads and nuts but I did not feel it was strong enough so I cut a hole to insert a 3/16" bolt and wing nut.
I did not add the holes in the back of the bracket as they were not needed due to the way they mount in my window. I can add them though if someone needs it.
Works great! plenty strong even with my blinds you manually pull down.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
