Slicer Discord
M5Stack ATOM Gridfinity – 3D-Druckmodell von MakerWorld MakerWorld
Other Hobby & DIY

M5Stack ATOM Gridfinity

5 Downloads
2 Likes
2 Makes
Zum Modell
The M5Stack ATOM is a small device that can be used to voice control your home automation. (would not recommend it as a speaker)I use it for Home Assistant.Recently I started building very nice monitor riser systems with Deskware and marked a nice spot for this little device.As it is a small and light device, the attached cable is has more weight and can easily topple the device.So the design is a tight fit to hold it steady.Using two Gridfinity units instead of one makes sure the cable does not lift the setup out of the grid.At the front I gave the microphone opening an extra rounding to gather more sound and it will be less directional. It has a magnet base, but I do not recommend using magnets in the front part that holds the unit, as magnets can influence the working of a microphone. Using magnets in the cable support part should not be a problem. However I did find the use of magnets is not needed at all for the flexible cable I use. Boost MeIf you like this design...A Boost is ve
Kategorie
Other Hobby & DIY
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen