Thingiverse
Mac Conversion Bracket
por ah_dee_das
0
Descargas
0
Likes
0
Makes
Had an old PowerPC Mac case a while back, and made a few changes to mount ATX hardware.
The front plate for the previous I/O was completely cut out, leaving a rectangular cut in the case. This cut was bridged by an adaptive bracket, allowing for the mounting of an ATX I/O panel.
The rest of the build featured a rewired switch (using the original but allowing it to work on the ATX motherboard) and mounting the PSU at the bottom of the case.
The front plate for the previous I/O was completely cut out, leaving a rectangular cut in the case. This cut was bridged by an adaptive bracket, allowing for the mounting of an ATX I/O panel.
The rest of the build featured a rewired switch (using the original but allowing it to work on the ATX motherboard) and mounting the PSU at the bottom of the case.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!