Thingiverse
Mac Conversion Bracket
door ah_dee_das
0
Downloads
0
Likes
0
Makes
Had an old PowerPC Mac case a while back, and made a few changes to mount ATX hardware.
The front plate for the previous I/O was completely cut out, leaving a rectangular cut in the case. This cut was bridged by an adaptive bracket, allowing for the mounting of an ATX I/O panel.
The rest of the build featured a rewired switch (using the original but allowing it to work on the ATX motherboard) and mounting the PSU at the bottom of the case.
The front plate for the previous I/O was completely cut out, leaving a rectangular cut in the case. This cut was bridged by an adaptive bracket, allowing for the mounting of an ATX I/O panel.
The rest of the build featured a rewired switch (using the original but allowing it to work on the ATX motherboard) and mounting the PSU at the bottom of the case.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!