Slicer Discord
Magic Snapper – 3D-Druckmodell von MakerWorld MakerWorld
Puzzles

Magic Snapper

1 Downloads
5 Likes
2 Makes
Zum Modell
This trick is super easy to learn, and will impress everyone! All you need to do is to hold the orange part, with your fingers on the slanted part, and then pinch really hard. This motion will send the orange piece flying into the green piece. I suggest pulling the orange part out 1.5 to 3 cm before snapping it back. The rubber band and washers are just to confuse the audience! The hook never actually touches the rubber band! To get the rubber band into the holes, I cut it so that is was more of a string than a band, then I put a twist tie on it, threaded the twist tie through, put the washers on both sides, then tied the rubber band on both ends.
Kategorie
Puzzles
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

1 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen