Slicer Discord
Magic Snapper – 3D-printbaar model van MakerWorld MakerWorld
Puzzles

Magic Snapper

door ronnoC817 · Puzzles
1 Downloads
5 Likes
2 Makes
Model downloaden
This trick is super easy to learn, and will impress everyone! All you need to do is to hold the orange part, with your fingers on the slanted part, and then pinch really hard. This motion will send the orange piece flying into the green piece. I suggest pulling the orange part out 1.5 to 3 cm before snapping it back. The rubber band and washers are just to confuse the audience! The hook never actually touches the rubber band! To get the rubber band into the holes, I cut it so that is was more of a string than a band, then I put a twist tie on it, threaded the twist tie through, put the washers on both sides, then tied the rubber band on both ends.
Categorie
Puzzles
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

2 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie