Thingiverse
Mark Williams
door twilliams151
2
Downloads
3
Likes
0
Makes
Magnet Holder designed for the Orbea Wild When changing wheels and fitting Hope Discs.
Infill 100% to add structure and strength.
Manets used - Neodymium Disc Countersunk Hole Magnets,JUNAN 20Pack 10mmx3mm hole 3mm Strong Permanent Rare Earth Magnets.
I got these from Amazon, You need 2 mangets for this holder to work.
Screws - M3x8mm Flat Head Machine Screws Inner Hex Screw 304 Stainless Steel Fasteners Bolts 40Pcs.
Again these came from Amazon, You only need 1 for this holder.
Disc Screws - M5 (5mm x 12mm) TX Pan Machine Screw (Bolt) - Stainless Steel (A2) (Pack of 20)
Again these came from Amazon, You need 2 of these to hold the holder in place.
I also put a small amount of super clue on the M3 screw to hold it in place.
Infill 100% to add structure and strength.
Manets used - Neodymium Disc Countersunk Hole Magnets,JUNAN 20Pack 10mmx3mm hole 3mm Strong Permanent Rare Earth Magnets.
I got these from Amazon, You need 2 mangets for this holder to work.
Screws - M3x8mm Flat Head Machine Screws Inner Hex Screw 304 Stainless Steel Fasteners Bolts 40Pcs.
Again these came from Amazon, You only need 1 for this holder.
Disc Screws - M5 (5mm x 12mm) TX Pan Machine Screw (Bolt) - Stainless Steel (A2) (Pack of 20)
Again these came from Amazon, You need 2 of these to hold the holder in place.
I also put a small amount of super clue on the M3 screw to hold it in place.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!