Thingiverse
Mask
von OraDigitale
7
Downloads
6
Likes
0
Makes
This mask is a DIY solution for the personal production of protective masks against the Covid19 virus.
Below are the manufacturing instructions.
Mask:
Once the 3d model is ready, heat the part with a phone and carefully fold the mask. Join the stitches with a seam and seal the inside with hot glue.
Filter:
To make the filter, you can use hygienic mats for pets. Cut out the filter with the paper pattern. Fold the filter in half. Combine with the stapler as shown. Insert the filter in the 3d printed mask.
The pattern can be made with 3d models.
Remember to sanitize the mask after each use.
Below are the manufacturing instructions.
Mask:
Once the 3d model is ready, heat the part with a phone and carefully fold the mask. Join the stitches with a seam and seal the inside with hot glue.
Filter:
To make the filter, you can use hygienic mats for pets. Cut out the filter with the paper pattern. Fold the filter in half. Combine with the stapler as shown. Insert the filter in the 3d printed mask.
The pattern can be made with 3d models.
Remember to sanitize the mask after each use.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
