Thingiverse
Mask
by OraDigitale
7
Downloads
6
Likes
0
Makes
This mask is a DIY solution for the personal production of protective masks against the Covid19 virus.
Below are the manufacturing instructions.
Mask:
Once the 3d model is ready, heat the part with a phone and carefully fold the mask. Join the stitches with a seam and seal the inside with hot glue.
Filter:
To make the filter, you can use hygienic mats for pets. Cut out the filter with the paper pattern. Fold the filter in half. Combine with the stapler as shown. Insert the filter in the 3d printed mask.
The pattern can be made with 3d models.
Remember to sanitize the mask after each use.
Below are the manufacturing instructions.
Mask:
Once the 3d model is ready, heat the part with a phone and carefully fold the mask. Join the stitches with a seam and seal the inside with hot glue.
Filter:
To make the filter, you can use hygienic mats for pets. Cut out the filter with the paper pattern. Fold the filter in half. Combine with the stapler as shown. Insert the filter in the 3d printed mask.
The pattern can be made with 3d models.
Remember to sanitize the mask after each use.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
