Thingiverse
Electronics
Zum Modell
Microscope arm mount
21
Downloads
68
Likes
0
Makes
A mount to attach to the microphone shockmount bracket.
Place the microscope and then tighten the screw to lock it in place. The mount is tapered to hold the microscope securely.
I designed this mount to be quick to print, not interfere with focus adjustment (regardless of position), facilitate access to the buttons, and allow the microscope to be rotated to adjust for use.
Dimensions:
Upper diameter - 30.4mm
Lower diameter - 27mm
Hole (fixation) - 6mm
Width (fixation) - 6.2mm
Place the microscope and then tighten the screw to lock it in place. The mount is tapered to hold the microscope securely.
I designed this mount to be quick to print, not interfere with focus adjustment (regardless of position), facilitate access to the buttons, and allow the microscope to be rotated to adjust for use.
Dimensions:
Upper diameter - 30.4mm
Lower diameter - 27mm
Hole (fixation) - 6mm
Width (fixation) - 6.2mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
