MorphBase1

This design uses methods shown in my other filletxxxx uploads here. This one is by far the largest - it printed in 40 1/4 hours using a layer height of 0.200 mm and a print speed of 120 mm/sec. The size is probably too large for Cartesian printers (it is just under 260 mm tall), but scaling it down to an appropriate size should work OK.

To allow printing with no supports I redesigned the basic shape several times. Consequently this part's curvature near the bottom is right at the edge of what my printer can do without supports. Other printers might need to use supports, but I found them difficult to use and not all that helpful.