Thingiverse
MPMD Probe Bracket
door tuffrabit
4
Downloads
1
Likes
0
Makes
An effector mounted bed probe bracket for the Monoprice Mini Delta.
https://www.youtube.com/watch?v=RBpWXpzyvAI
Parts needed:
* 12x3mm disc magnets (three of them)
* Creality endstop switch PCB (I used the Z endstop from my Ender 3)
You may have to glue the magnets in, but I was able to just friction fit them. This mod assumes you have sufficient knowledge of how to tweak firmware or otherwise mod and wire your printer. I accompanied this probe with a SKR board and Marlin 2.x. I'm not confident this probe will be useful or usable on a stock MPMD.
https://www.youtube.com/watch?v=RBpWXpzyvAI
Parts needed:
* 12x3mm disc magnets (three of them)
* Creality endstop switch PCB (I used the Z endstop from my Ender 3)
You may have to glue the magnets in, but I was able to just friction fit them. This mod assumes you have sufficient knowledge of how to tweak firmware or otherwise mod and wire your printer. I accompanied this probe with a SKR board and Marlin 2.x. I'm not confident this probe will be useful or usable on a stock MPMD.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
