Thingiverse
MPMini Raspberry Pi Camera Mount
por JeremyLaurenson
8
Descargas
9
Likes
0
Makes
This is a mount for a Raspberry Pi camera that attaches to the front of the bed using the two existing screws. It points the camera at the middle of the bed and is simple to use.
Be careful attaching your camera (I use hotglue) so that the board is not too far to the left or it will interfere with the stock fan on the hotend.
With the standard hotend, the camera should be mounted dead center.
You can adjust your cmera focus as described here: http://elinux.org/Rpi_Camera_Module#Adjusting_Lens_Focus
Be careful attaching your camera (I use hotglue) so that the board is not too far to the left or it will interfere with the stock fan on the hotend.
With the standard hotend, the camera should be mounted dead center.
You can adjust your cmera focus as described here: http://elinux.org/Rpi_Camera_Module#Adjusting_Lens_Focus
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
