MakerWorld
Gadgets
Ver Modelo
Nitecore TIP flashlight shell
8
Descargas
1
Likes
3
Makes
A replacement shell for the Nitecore TIP (V1). 1mm thick, 0.5mm detail, should work on both MSLA and FDM.No supports needed.In order to get maximum transparency using MSLA I used a clear resin (Anycubic Clear), printed the object flat on the build plate, cured in water (after washing) and gave it a few coats of clear spraypaint.The Anycubic clear resin is pretty brittle, so take care not to over-tighten the screws. Siraya Tech Blu would probably be best if you want something tough and transparent, but as I don't have any, I had to make do.
Citruspers también publica en
71 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
