Slicer Discord
pMic – 3D-Druckmodell von Thingiverse Thingiverse
pMic – Bild 1 pMic – Bild 2 pMic – Bild 3 pMic – Bild 4 pMic – Bild 5 pMic – Bild 6
Music

pMic

von fpiesik · Music
27 Downloads
26 Likes
0 Makes
Zum Modell
A printable A-B-Stereo Microphone

I wanted to have a mic which I cought use for general purpose recording in conjunction with my old iriver h120 (with rockbox installed). I didn't found a suitable mic without a build in recorder:)

So after a little bit googleing I found this article about a low-cost
homebrew solution http://www.wildlife-sound.org/equipment/technote/micdesigns/ and decided to get a bunch of these panasonic wm61-capsules described in the article to start experimenting with them - here is the result.

A special feature of this microphone is it's variable stereo width (by time-of-arrival stereophony).

The button near the audio jack is the on/off-swiitch, the second one a gain boost. By swapping two resistors in the circuit, the gain boost could be easily converted to a gain damp. The preamp circuit isn't necessary at all, if your recorders preamp has phantom power. But the 9v battery increases the headroom for louder signals and powers the 4 capsules more c
Kategorie
Music
Quelle
Thingiverse
Veröffentlicht
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen