Slicer Discord
pMic – 3D-printbaar model van Thingiverse Thingiverse
pMic – Bild 1 pMic – Bild 2 pMic – Bild 3 pMic – Bild 4 pMic – Bild 5 pMic – Bild 6
Music

pMic

door fpiesik · Music
27 Downloads
26 Likes
0 Makes
Model downloaden
A printable A-B-Stereo Microphone

I wanted to have a mic which I cought use for general purpose recording in conjunction with my old iriver h120 (with rockbox installed). I didn't found a suitable mic without a build in recorder:)

So after a little bit googleing I found this article about a low-cost
homebrew solution http://www.wildlife-sound.org/equipment/technote/micdesigns/ and decided to get a bunch of these panasonic wm61-capsules described in the article to start experimenting with them - here is the result.

A special feature of this microphone is it's variable stereo width (by time-of-arrival stereophony).

The button near the audio jack is the on/off-swiitch, the second one a gain boost. By swapping two resistors in the circuit, the gain boost could be easily converted to a gain damp. The preamp circuit isn't necessary at all, if your recorders preamp has phantom power. But the 9v battery increases the headroom for louder signals and powers the 4 capsules more c
Categorie
Music
Bron
Thingiverse
Gepubliceerd
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie