Thingiverse
Polygno Flow Sensor Case-bracket
von polygno
0
Downloads
0
Likes
0
Makes
Case & mount for the Polygno Flow Sensor.
Ideal for a direct-drive printer.
You can use 2x T-slot nuts and M4 screws to secure this to v-slot frames.
4x M2 screws hold the sensor in the case
2x M2 screws secure the two halves of the case
Small button fits through the hole in the case to allow the reset button to be pressed.
Ideal for a direct-drive printer.
You can use 2x T-slot nuts and M4 screws to secure this to v-slot frames.
4x M2 screws hold the sensor in the case
2x M2 screws secure the two halves of the case
Small button fits through the hole in the case to allow the reset button to be pressed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!