Thingiverse
Polygno Flow Sensor Case-bracket
by polygno
0
Downloads
0
Likes
0
Makes
Case & mount for the Polygno Flow Sensor.
Ideal for a direct-drive printer.
You can use 2x T-slot nuts and M4 screws to secure this to v-slot frames.
4x M2 screws hold the sensor in the case
2x M2 screws secure the two halves of the case
Small button fits through the hole in the case to allow the reset button to be pressed.
Ideal for a direct-drive printer.
You can use 2x T-slot nuts and M4 screws to secure this to v-slot frames.
4x M2 screws hold the sensor in the case
2x M2 screws secure the two halves of the case
Small button fits through the hole in the case to allow the reset button to be pressed.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!