Thingiverse
Pool Hose Float
von raevenfairchilde
0
Downloads
1
Likes
0
Makes
Designed in Tinkercad, Sliced in Cura, Printed on Ender 3
O.D. - ~75mm
I.D. (to wrap hose) - 47.11mm (1.85")
Length - 126.7mm (5")
1" (25.5mm) gap down the center to squeeze in the hose
Print settings I used (adjust as needed)
200 / 60 temps
No Supports / Adhesion
15% infill to give buoyance
Placed on 4 foot hose section closest to Krawlie, before connection to next hose section. This was an exact fit for the Zodiac Pool Systems hose.
O.D. - ~75mm
I.D. (to wrap hose) - 47.11mm (1.85")
Length - 126.7mm (5")
1" (25.5mm) gap down the center to squeeze in the hose
Print settings I used (adjust as needed)
200 / 60 temps
No Supports / Adhesion
15% infill to give buoyance
Placed on 4 foot hose section closest to Krawlie, before connection to next hose section. This was an exact fit for the Zodiac Pool Systems hose.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!