Thingiverse
Pool Hose Float
door raevenfairchilde
0
Downloads
1
Likes
0
Makes
Designed in Tinkercad, Sliced in Cura, Printed on Ender 3
O.D. - ~75mm
I.D. (to wrap hose) - 47.11mm (1.85")
Length - 126.7mm (5")
1" (25.5mm) gap down the center to squeeze in the hose
Print settings I used (adjust as needed)
200 / 60 temps
No Supports / Adhesion
15% infill to give buoyance
Placed on 4 foot hose section closest to Krawlie, before connection to next hose section. This was an exact fit for the Zodiac Pool Systems hose.
O.D. - ~75mm
I.D. (to wrap hose) - 47.11mm (1.85")
Length - 126.7mm (5")
1" (25.5mm) gap down the center to squeeze in the hose
Print settings I used (adjust as needed)
200 / 60 temps
No Supports / Adhesion
15% infill to give buoyance
Placed on 4 foot hose section closest to Krawlie, before connection to next hose section. This was an exact fit for the Zodiac Pool Systems hose.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!