Thingiverse
Pool Hose Float
por raevenfairchilde
0
Descargas
1
Likes
0
Makes
Designed in Tinkercad, Sliced in Cura, Printed on Ender 3
O.D. - ~75mm
I.D. (to wrap hose) - 47.11mm (1.85")
Length - 126.7mm (5")
1" (25.5mm) gap down the center to squeeze in the hose
Print settings I used (adjust as needed)
200 / 60 temps
No Supports / Adhesion
15% infill to give buoyance
Placed on 4 foot hose section closest to Krawlie, before connection to next hose section. This was an exact fit for the Zodiac Pool Systems hose.
O.D. - ~75mm
I.D. (to wrap hose) - 47.11mm (1.85")
Length - 126.7mm (5")
1" (25.5mm) gap down the center to squeeze in the hose
Print settings I used (adjust as needed)
200 / 60 temps
No Supports / Adhesion
15% infill to give buoyance
Placed on 4 foot hose section closest to Krawlie, before connection to next hose section. This was an exact fit for the Zodiac Pool Systems hose.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!