Thingiverse
Printing problems
von Lommen
2
Downloads
6
Likes
1
Makes
Hi all 3D printer fanatics out there!
I have a problem I can't figure out whats wrong. Maybe some one out there have a clue what the issue can be!
I have drawn a detail in 123D design. Exported it as sal with the settings "fine". Imported in Simplify3D and tried to print it out. After approx. 7 mm of printing hight there seems to be a week layer and i can't figure out why. I tried to print a similar detail 2 weeks ago and that part shows exactly the same symptom. I have a Vertex 8402 3D printer and run this project with black ABS with a temperature about 230 degrees at a speed of 2400 mm/min.
Take a look att the images and see if you have a clue. i'm most grateful to anyone how can bring some light into my darkness.
I have a problem I can't figure out whats wrong. Maybe some one out there have a clue what the issue can be!
I have drawn a detail in 123D design. Exported it as sal with the settings "fine". Imported in Simplify3D and tried to print it out. After approx. 7 mm of printing hight there seems to be a week layer and i can't figure out why. I tried to print a similar detail 2 weeks ago and that part shows exactly the same symptom. I have a Vertex 8402 3D printer and run this project with black ABS with a temperature about 230 degrees at a speed of 2400 mm/min.
Take a look att the images and see if you have a clue. i'm most grateful to anyone how can bring some light into my darkness.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!