Thingiverse
Printing problems
by Lommen
2
Downloads
6
Likes
1
Makes
Hi all 3D printer fanatics out there!
I have a problem I can't figure out whats wrong. Maybe some one out there have a clue what the issue can be!
I have drawn a detail in 123D design. Exported it as sal with the settings "fine". Imported in Simplify3D and tried to print it out. After approx. 7 mm of printing hight there seems to be a week layer and i can't figure out why. I tried to print a similar detail 2 weeks ago and that part shows exactly the same symptom. I have a Vertex 8402 3D printer and run this project with black ABS with a temperature about 230 degrees at a speed of 2400 mm/min.
Take a look att the images and see if you have a clue. i'm most grateful to anyone how can bring some light into my darkness.
I have a problem I can't figure out whats wrong. Maybe some one out there have a clue what the issue can be!
I have drawn a detail in 123D design. Exported it as sal with the settings "fine". Imported in Simplify3D and tried to print it out. After approx. 7 mm of printing hight there seems to be a week layer and i can't figure out why. I tried to print a similar detail 2 weeks ago and that part shows exactly the same symptom. I have a Vertex 8402 3D printer and run this project with black ABS with a temperature about 230 degrees at a speed of 2400 mm/min.
Take a look att the images and see if you have a clue. i'm most grateful to anyone how can bring some light into my darkness.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!