Thingiverse
Quick Print Faceshield
von In2Go
13
Downloads
12
Likes
0
Makes
A lot of the designs I was seeing available used too much filament for what was needed, was not comfortable on the head, or secure enough...and had some spare time for some reason :).... so here is my quick print face shield design. Can print 3 on a 200x200mm in less that 2 hours with very conservative settings.
Clear plastic in picture was cut from a plastic clamshell packaging for a mirror but can use any clear plastic like a transparency or 2 liter bottle. Use a hole punch to punch three holes spaced 2.75 inches apart (or a 3 hole punch set as such) and some rubber bands. The headband is pretty flexible, even with PLA, and quite comfortable but if wrapped with a paper towel I could wear it all day. Can be worn with glasses and small N95 masks.
***THIS WILL NOT STOP THE SPREAD OF COVID-19 OR GERMS*** Only meant to serve as a personal reminder not to touch your face while completing absolutely essential tasks!!
Clear plastic in picture was cut from a plastic clamshell packaging for a mirror but can use any clear plastic like a transparency or 2 liter bottle. Use a hole punch to punch three holes spaced 2.75 inches apart (or a 3 hole punch set as such) and some rubber bands. The headband is pretty flexible, even with PLA, and quite comfortable but if wrapped with a paper towel I could wear it all day. Can be worn with glasses and small N95 masks.
***THIS WILL NOT STOP THE SPREAD OF COVID-19 OR GERMS*** Only meant to serve as a personal reminder not to touch your face while completing absolutely essential tasks!!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!