Thingiverse
Quick Print Faceshield
por In2Go
13
Descargas
12
Likes
0
Makes
A lot of the designs I was seeing available used too much filament for what was needed, was not comfortable on the head, or secure enough...and had some spare time for some reason :).... so here is my quick print face shield design. Can print 3 on a 200x200mm in less that 2 hours with very conservative settings.
Clear plastic in picture was cut from a plastic clamshell packaging for a mirror but can use any clear plastic like a transparency or 2 liter bottle. Use a hole punch to punch three holes spaced 2.75 inches apart (or a 3 hole punch set as such) and some rubber bands. The headband is pretty flexible, even with PLA, and quite comfortable but if wrapped with a paper towel I could wear it all day. Can be worn with glasses and small N95 masks.
***THIS WILL NOT STOP THE SPREAD OF COVID-19 OR GERMS*** Only meant to serve as a personal reminder not to touch your face while completing absolutely essential tasks!!
Clear plastic in picture was cut from a plastic clamshell packaging for a mirror but can use any clear plastic like a transparency or 2 liter bottle. Use a hole punch to punch three holes spaced 2.75 inches apart (or a 3 hole punch set as such) and some rubber bands. The headband is pretty flexible, even with PLA, and quite comfortable but if wrapped with a paper towel I could wear it all day. Can be worn with glasses and small N95 masks.
***THIS WILL NOT STOP THE SPREAD OF COVID-19 OR GERMS*** Only meant to serve as a personal reminder not to touch your face while completing absolutely essential tasks!!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
