Thingiverse
Quick Spool roller hack
par siderits
1
Téléchargements
2
Likes
0
Makes
This is a very simple low tension spool holder that uses a 3 inch flat roller bearing (thrust bearing) from all electronics and a cookie tin lid.
The one I used holds a 1kg spool perfectly. Its easy to swap them out because the bearing has two parts. This means that you can quickly seat a larger lid and spool on the lower half of the bearing.
The bearing cast about 1.50$ at Allelectronics.com
http://www.allelectronics.com/make-a-store/item/BR-9/3-THRUST-BEARING/1.html
Center the bearing on the bottom of the cookie tin lid and use double stick tape to hold it in place.
The one I used holds a 1kg spool perfectly. Its easy to swap them out because the bearing has two parts. This means that you can quickly seat a larger lid and spool on the lower half of the bearing.
The bearing cast about 1.50$ at Allelectronics.com
http://www.allelectronics.com/make-a-store/item/BR-9/3-THRUST-BEARING/1.html
Center the bearing on the bottom of the cookie tin lid and use double stick tape to hold it in place.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
