Thingiverse
Quick Spool roller hack
door siderits
1
Downloads
2
Likes
0
Makes
This is a very simple low tension spool holder that uses a 3 inch flat roller bearing (thrust bearing) from all electronics and a cookie tin lid.
The one I used holds a 1kg spool perfectly. Its easy to swap them out because the bearing has two parts. This means that you can quickly seat a larger lid and spool on the lower half of the bearing.
The bearing cast about 1.50$ at Allelectronics.com
http://www.allelectronics.com/make-a-store/item/BR-9/3-THRUST-BEARING/1.html
Center the bearing on the bottom of the cookie tin lid and use double stick tape to hold it in place.
The one I used holds a 1kg spool perfectly. Its easy to swap them out because the bearing has two parts. This means that you can quickly seat a larger lid and spool on the lower half of the bearing.
The bearing cast about 1.50$ at Allelectronics.com
http://www.allelectronics.com/make-a-store/item/BR-9/3-THRUST-BEARING/1.html
Center the bearing on the bottom of the cookie tin lid and use double stick tape to hold it in place.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
