Thingiverse
Raspberry Pi Game Console
von m4rc3lv
15
Downloads
13
Likes
0
Makes
This is a case for my game console. It hosts a Raspberry Pi 3, a small NeoPixel LED ring and a 9 pin Sub-D connector.
The lid is screwed using M4 bolts that are tightened using screw-in nuts (M4 screw-in nuts fit in the 4 corner holes of the case).
The Sub-D connector is fitted using M3 bolts+nuts.
The Raspberry Pi is mounted using M3 screws. The holes for that were drilled after printing. I glued 4 rubber feet under the console.
Printing: no supports were used at all. The dome was printed using neutral colored PLA.
The text "Fit Console" can be changed within the Openscad file.
The lid is screwed using M4 bolts that are tightened using screw-in nuts (M4 screw-in nuts fit in the 4 corner holes of the case).
The Sub-D connector is fitted using M3 bolts+nuts.
The Raspberry Pi is mounted using M3 screws. The holes for that were drilled after printing. I glued 4 rubber feet under the console.
Printing: no supports were used at all. The dome was printed using neutral colored PLA.
The text "Fit Console" can be changed within the Openscad file.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
