Thingiverse
Shelf Bracket
14
Downloads
11
Likes
0
Makes
➤ My first upload. Just a simple shelf-bracket I created in Fusion 360.
➤ I used #8x2" (#8x5cm) wood screws. This is meant to be screwed directly into stud.
➤ I was able to print two of these brackets on my 235mm x 235m x 400mm buildplate.
(I had to expand the buildplate area from the default Ender 3 Pro setting in Cura. This is done by clicking "Preferences" in the top-left, "configure","printers","machine settings", and then changing the x and y printer parameters to "235" respectively. This increases the bed size to the actual limits of the Ender 3 Pro stock buildplate.)
➤ Print time is about 11 hours for two, or a little under 6 hours for one.
➤ I used these brackets to hang a shelf above our washer and dryer.
➤ I would love to see what others use this for! Thanks
➤ I used #8x2" (#8x5cm) wood screws. This is meant to be screwed directly into stud.
➤ I was able to print two of these brackets on my 235mm x 235m x 400mm buildplate.
(I had to expand the buildplate area from the default Ender 3 Pro setting in Cura. This is done by clicking "Preferences" in the top-left, "configure","printers","machine settings", and then changing the x and y printer parameters to "235" respectively. This increases the bed size to the actual limits of the Ender 3 Pro stock buildplate.)
➤ Print time is about 11 hours for two, or a little under 6 hours for one.
➤ I used these brackets to hang a shelf above our washer and dryer.
➤ I would love to see what others use this for! Thanks
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!