Thingiverse
simple calibration
by trget
7
Downloads
4
Likes
0
Makes
The three layers are 5mm, 15mm and 20mm. they are measured then a proportion is found. These are then averaged to find the required proportion of the current steps.
example:
a = lowest step
b = mid step
c= total height
d = desired proportion
[(5mm/a)+(15mm/b)+(20mm/c)] /3= d
this will then be multiplied by the original setting (if still stock, in sprinter, equals 2560) in your Arduino interface.
example:
a = lowest step
b = mid step
c= total height
d = desired proportion
[(5mm/a)+(15mm/b)+(20mm/c)] /3= d
this will then be multiplied by the original setting (if still stock, in sprinter, equals 2560) in your Arduino interface.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!