Thingiverse
simple calibration
por trget
7
Descargas
4
Likes
0
Makes
The three layers are 5mm, 15mm and 20mm. they are measured then a proportion is found. These are then averaged to find the required proportion of the current steps.
example:
a = lowest step
b = mid step
c= total height
d = desired proportion
[(5mm/a)+(15mm/b)+(20mm/c)] /3= d
this will then be multiplied by the original setting (if still stock, in sprinter, equals 2560) in your Arduino interface.
example:
a = lowest step
b = mid step
c= total height
d = desired proportion
[(5mm/a)+(15mm/b)+(20mm/c)] /3= d
this will then be multiplied by the original setting (if still stock, in sprinter, equals 2560) in your Arduino interface.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!