Simple DB23

This is a quick and simple DB25 to DB23 conversion I made for an Amiga 500 floppy drive project.
I used a drill to remove the lip from the holes at each end of the DB25 (without going through) and separated the front and back.
Then remove pins 1 and 13, rotate 180 degrees and use a couple of screws to make your DB-23.
I've added a small countersink to DB23-CS if you want to use 3mm countersink screws and nuts and keep that side flush.

**Note - My Amiga hasn't got the posts in the DB23 port and they will stop this pushing all the way home!

Printed on an Ender 3 V2 using 'Super Quality' and 100% infill.