Thingiverse
Simple DB23
door jimbo69
3
Downloads
10
Likes
0
Makes
This is a quick and simple DB25 to DB23 conversion I made for an Amiga 500 floppy drive project.
I used a drill to remove the lip from the holes at each end of the DB25 (without going through) and separated the front and back.
Then remove pins 1 and 13, rotate 180 degrees and use a couple of screws to make your DB-23.
I've added a small countersink to DB23-CS if you want to use 3mm countersink screws and nuts and keep that side flush.
**Note - My Amiga hasn't got the posts in the DB23 port and they will stop this pushing all the way home!
Printed on an Ender 3 V2 using 'Super Quality' and 100% infill.
I used a drill to remove the lip from the holes at each end of the DB25 (without going through) and separated the front and back.
Then remove pins 1 and 13, rotate 180 degrees and use a couple of screws to make your DB-23.
I've added a small countersink to DB23-CS if you want to use 3mm countersink screws and nuts and keep that side flush.
**Note - My Amiga hasn't got the posts in the DB23 port and they will stop this pushing all the way home!
Printed on an Ender 3 V2 using 'Super Quality' and 100% infill.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!