Thingiverse
simple temp block
von pfilipe
0
Downloads
0
Likes
0
Makes
In the gcode, look for the M104 command. Example:
M104 S205 ; set temperature
Then add it to the gcode produced from your slicer, after the end blocks, like this:
...
G92 E0
M104 S200 ; set temperature
G1 Z10.200 F7800.000
...
Set the correct temp based on the Z location from the command:
M104 S205 ; set temperature
Then add it to the gcode produced from your slicer, after the end blocks, like this:
...
G92 E0
M104 S200 ; set temperature
G1 Z10.200 F7800.000
...
Set the correct temp based on the Z location from the command:
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!