Thingiverse
Softputer
von SputnikRSS
1
Downloads
0
Likes
0
Makes
This is a toy computer (aka the softputer) made for my kids. It is about 7" across by about 5" deep.
I included the step file for the screen so you can add a customized logo or such to the back of the monitor section.
The keys are printed in TPU at 2 walls and 15% infill so they squish down when pressed.
The rest is printed in PLA at 4walls and about 25% infill.
Both at 0.2mm layer height
You will need 2x M3x20mm socket cap screws and 4 x M3x12mm socket cap screws for putting the computer together plus the 6x M3 nuts.
I included the step file for the screen so you can add a customized logo or such to the back of the monitor section.
The keys are printed in TPU at 2 walls and 15% infill so they squish down when pressed.
The rest is printed in PLA at 4walls and about 25% infill.
Both at 0.2mm layer height
You will need 2x M3x20mm socket cap screws and 4 x M3x12mm socket cap screws for putting the computer together plus the 6x M3 nuts.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
