Thingiverse
Split pin set
von fjkraan
5
Downloads
9
Likes
0
Makes
This is a an contraption to attach two thin sheets through a hole in both.The two halves are printed laying down, as an upright print is a considerably weaker construction. The current STL file requires a 4.5 mm hole. But the SCAD file allow you to resize at will.
The ring is actual optional if the sheets are sturdy enough.
The pin is not printed at all, it is a piece of filament as it comes from the spool.
The ring is actual optional if the sheets are sturdy enough.
The pin is not printed at all, it is a piece of filament as it comes from the spool.
fjkraan veröffentlicht auch auf
48 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!