Thingiverse
Squidpole Endcap
door timmo710
0
Downloads
0
Likes
0
Makes
Endcap to replace broken one on my 7M Squid pole.
Created in tinkercad.
Printed with 20% infill with ABS (can also be PLA) with Tevo Tarantula. 0.2 layer height is fine.
The one in the picture stopped printing near the end so it doesnt butt up to the base properly.
Created in tinkercad.
Printed with 20% infill with ABS (can also be PLA) with Tevo Tarantula. 0.2 layer height is fine.
The one in the picture stopped printing near the end so it doesnt butt up to the base properly.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!