Thingiverse
Squidpole Endcap
por timmo710
0
Descargas
0
Likes
0
Makes
Endcap to replace broken one on my 7M Squid pole.
Created in tinkercad.
Printed with 20% infill with ABS (can also be PLA) with Tevo Tarantula. 0.2 layer height is fine.
The one in the picture stopped printing near the end so it doesnt butt up to the base properly.
Created in tinkercad.
Printed with 20% infill with ABS (can also be PLA) with Tevo Tarantula. 0.2 layer height is fine.
The one in the picture stopped printing near the end so it doesnt butt up to the base properly.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!