Thingiverse
Squidpole Endcap
von timmo710
0
Downloads
0
Likes
0
Makes
Endcap to replace broken one on my 7M Squid pole.
Created in tinkercad.
Printed with 20% infill with ABS (can also be PLA) with Tevo Tarantula. 0.2 layer height is fine.
The one in the picture stopped printing near the end so it doesnt butt up to the base properly.
Created in tinkercad.
Printed with 20% infill with ABS (can also be PLA) with Tevo Tarantula. 0.2 layer height is fine.
The one in the picture stopped printing near the end so it doesnt butt up to the base properly.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!