Thingiverse
Stackable plant support stick
von Fupuf
41
Downloads
38
Likes
0
Makes
Stackable plant support stick.
To securely join two sticks you need either a wire or, my preffered method, a short filament piece.
Pass the filament piece though the hole one two sticks are joined together. You then heat up the filament piece and press fit it against the stick. Do this on both sides and you have a clean and secure connection.
Supports not needed.
I am satisfied with 10% infill and 0.8mm walls.
To securely join two sticks you need either a wire or, my preffered method, a short filament piece.
Pass the filament piece though the hole one two sticks are joined together. You then heat up the filament piece and press fit it against the stick. Do this on both sides and you have a clean and secure connection.
Supports not needed.
I am satisfied with 10% infill and 0.8mm walls.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
