Thingiverse
Stackable plant support stick
por Fupuf
41
Descargas
38
Likes
0
Makes
Stackable plant support stick.
To securely join two sticks you need either a wire or, my preffered method, a short filament piece.
Pass the filament piece though the hole one two sticks are joined together. You then heat up the filament piece and press fit it against the stick. Do this on both sides and you have a clean and secure connection.
Supports not needed.
I am satisfied with 10% infill and 0.8mm walls.
To securely join two sticks you need either a wire or, my preffered method, a short filament piece.
Pass the filament piece though the hole one two sticks are joined together. You then heat up the filament piece and press fit it against the stick. Do this on both sides and you have a clean and secure connection.
Supports not needed.
I am satisfied with 10% infill and 0.8mm walls.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
