Thingiverse
Stackable rack
von jesse1990
54
Downloads
37
Likes
1
Makes
A stackable rack
Next to my television there is a modem, router and a few raspberry pi's. For these devices I have made a stackable rack. This allows these devices to stand on top of each other. There is a lot of room for draining hot air.
If you print more, they can be stacked. Print the rack upside down and use support for the 4 corners. Because the hot air can escape well, I went for PLA.
Next to my television there is a modem, router and a few raspberry pi's. For these devices I have made a stackable rack. This allows these devices to stand on top of each other. There is a lot of room for draining hot air.
If you print more, they can be stacked. Print the rack upside down and use support for the 4 corners. Because the hot air can escape well, I went for PLA.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
