Thingiverse
Stackable rack
por jesse1990
54
Descargas
37
Likes
1
Makes
A stackable rack
Next to my television there is a modem, router and a few raspberry pi's. For these devices I have made a stackable rack. This allows these devices to stand on top of each other. There is a lot of room for draining hot air.
If you print more, they can be stacked. Print the rack upside down and use support for the 4 corners. Because the hot air can escape well, I went for PLA.
Next to my television there is a modem, router and a few raspberry pi's. For these devices I have made a stackable rack. This allows these devices to stand on top of each other. There is a lot of room for draining hot air.
If you print more, they can be stacked. Print the rack upside down and use support for the 4 corners. Because the hot air can escape well, I went for PLA.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
