Thingiverse
Stackable Sieve
von les_kaye
130
Downloads
90
Likes
0
Makes
Stackable Sieve
==========
Sieve frame with insert to take a wire mesh approximately 150mm (6 inches) square.
The outside is 155mm square which is the largest that will fit on my print bed. The sieve has a coarse mesh to support your wire mesh or with no support if you are not giving it hard use.
I provide a pot to catch your powder.
There is a lid which can be useful when shaking the sieve.
Print the box, cut your sieve mesh to fit using the insert as a size guide then glue all in place with an impact adhesive.
This should be printed in a plastic with good layer adhesion. Use PLA or PETG as ABS will warp.
==========
Sieve frame with insert to take a wire mesh approximately 150mm (6 inches) square.
The outside is 155mm square which is the largest that will fit on my print bed. The sieve has a coarse mesh to support your wire mesh or with no support if you are not giving it hard use.
I provide a pot to catch your powder.
There is a lid which can be useful when shaking the sieve.
Print the box, cut your sieve mesh to fit using the insert as a size guide then glue all in place with an impact adhesive.
This should be printed in a plastic with good layer adhesion. Use PLA or PETG as ABS will warp.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
