Thingiverse
Stackable Sieve
por les_kaye
130
Descargas
90
Likes
0
Makes
Stackable Sieve
==========
Sieve frame with insert to take a wire mesh approximately 150mm (6 inches) square.
The outside is 155mm square which is the largest that will fit on my print bed. The sieve has a coarse mesh to support your wire mesh or with no support if you are not giving it hard use.
I provide a pot to catch your powder.
There is a lid which can be useful when shaking the sieve.
Print the box, cut your sieve mesh to fit using the insert as a size guide then glue all in place with an impact adhesive.
This should be printed in a plastic with good layer adhesion. Use PLA or PETG as ABS will warp.
==========
Sieve frame with insert to take a wire mesh approximately 150mm (6 inches) square.
The outside is 155mm square which is the largest that will fit on my print bed. The sieve has a coarse mesh to support your wire mesh or with no support if you are not giving it hard use.
I provide a pot to catch your powder.
There is a lid which can be useful when shaking the sieve.
Print the box, cut your sieve mesh to fit using the insert as a size guide then glue all in place with an impact adhesive.
This should be printed in a plastic with good layer adhesion. Use PLA or PETG as ABS will warp.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
