Thingiverse
Support test
by Marrownauch
8
Downloads
9
Likes
0
Makes
I remixed from Arkinto's "Overhang Slab" this to help adjust support settings for multiple needs when printing. Should be able to print as is.
Tip: If you're doing multiple prints, when you finish a print, use a fine point sharpie to write the settings you changed on top. I also like to write which print it was. (i.e. #1, #2, #3)
Tip: If you're doing multiple prints, when you finish a print, use a fine point sharpie to write the settings you changed on top. I also like to write which print it was. (i.e. #1, #2, #3)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
