Thingiverse
Support test
par Marrownauch
8
Téléchargements
9
Likes
0
Makes
I remixed from Arkinto's "Overhang Slab" this to help adjust support settings for multiple needs when printing. Should be able to print as is.
Tip: If you're doing multiple prints, when you finish a print, use a fine point sharpie to write the settings you changed on top. I also like to write which print it was. (i.e. #1, #2, #3)
Tip: If you're doing multiple prints, when you finish a print, use a fine point sharpie to write the settings you changed on top. I also like to write which print it was. (i.e. #1, #2, #3)
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
