Thingiverse
Support test
por Marrownauch
8
Descargas
9
Likes
0
Makes
I remixed from Arkinto's "Overhang Slab" this to help adjust support settings for multiple needs when printing. Should be able to print as is.
Tip: If you're doing multiple prints, when you finish a print, use a fine point sharpie to write the settings you changed on top. I also like to write which print it was. (i.e. #1, #2, #3)
Tip: If you're doing multiple prints, when you finish a print, use a fine point sharpie to write the settings you changed on top. I also like to write which print it was. (i.e. #1, #2, #3)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
