Thingiverse
Test_Leveling
von Ron07
1
Downloads
1
Likes
0
Makes
Test to find best slicer - config
Print first 30x30x0.2mm (is first layer only by layer-high = 0.2mm) until this is fine.
And only then print 20x20x5mm for check height, width, depth and perfect corners.
And last find the perfect surface for your needs.
Print first 30x30x0.2mm (is first layer only by layer-high = 0.2mm) until this is fine.
And only then print 20x20x5mm for check height, width, depth and perfect corners.
And last find the perfect surface for your needs.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!